Made-Rite

Made Rite™ introduces Snap-on Baseboards™ the patented snap-on baseboard system. This two part system creates a covered channel behind the outer baseboard profile that clips to the wall-attached inner profile. The baseboard can be removed and replaced at will for wall inspection, or access and updates to a variety of electrical and data cables. Snap-on Baseboards™ is easy to install and convenient anywhere modular access is common or necessary; termite inspection, office cubicles, mobile homes, new wiring or security installations, to name a few. Once purchased this system will provide a lifetime of use and benefits that no other baseboard offers.

• Easy to install
• Will not absorb moisture.
• Pre-Finished, but paintable.
• No more wall damage when removing trim for termite or mold inspection

• No more messy glue
installation
• Easy to change out cables
• Matching inside and outside
corner clips

Snap-On Baseboard System™

Profile

Code

Pattern

Size

Length

Weight Per
Carton

Pieces Per
Carton

0245-0112-986

Snap-On
Baseboard

3 1/4" 9/16"

12'

35 lbs.

B9000

Baseboard
Wall Clip

B9010

Inside
Corner Clip

B9020

Outside
Corner Clip

Advantages • Will not rot. Resists mildew and fungus. • Will not absorb moisture. • Excellent R value. • Carries a UL-VO-94 fire rating. • Smoke contribution is well below ASTM standards. • Passed salt water exposure of 1000 hrs. • Surface hardness is superior to pine.		Painting Painting of millwork profiles is not required for varying periods of time, depending on exposure to ultraviolet rays and pollution. Should painting be desired, follow these instructions: • Clean surface to be painted. • For a good one-step process, paint surface with acrylic exterior latex paint. • For latex paint, use a latex or acrylic primer before applying the finish coat.

Joining or fastening • Recommended screws: Drywall screws with large thread or flute. • Recommended adhesive: Sub-floor adhesive or PVC cement. • Holes can be filled with colored caulk or putty. • To raise dents or marks on the profiles, use a hair dryer.		Oil Base Paints • Lightly sand surface. • Paint surface with fast-drying alkyd primer. • Allow to dry. • Apply finish coat.

web design by Reliant Design Studio